Follow-ups left open by TxMode::no_agg / NOAGG (#459)

未关闭
#462 0 条评论 0 个 reaction 已指派 0 人 在 GitHub 查看

维护者通常 1 天内回复

还没有人认领这个 Issue。

评估

难度
5/5
预计耗时
一周以上
新手友好度
25/100
Issue 类型
功能
描述清晰度
描述清楚
活跃度
活跃
技术栈
c, linux
领域
networking

调研方向

Start with tests/tx_no_agg_onair.sh for the measurement follow-ups; the issue names no code entry point for the driver ports. First determine which follow-up has suitable hardware and a reproducible bench, then read the prior results from #459. Done means delivering the requested measurements or a validated on-air port; several investigations remain open-ended and hardware-dependent.

由索引模型根据 Issue 内容生成。

描述

enhancement

Left open by #459 (TxMode::no_agg / /NOAGG, merged as 87dde96). None blocks the feature as shipped; each is a measurement or a port the PR explicitly did not claim.

  • Cost of occasional flagged frames. Only the every-other-frame worst case was measured (−47 % heard on the 8812EU, −60 % on the 8812CU). The realistic shape, one control frame every N aggregated video frames, is unmeasured. tests/tx_no_agg_onair.sh needs a duty knob (flag every Nth frame) and a goodput reading, not a heard-fps one.
  • Mixed-width fold. The A-MPDU folds bandwidth as well as rate (a 20 MHz frame behind a 40 MHz opener airs at 40). The harness scores rate only. Add a width arm once the witness's rx.seq carries the decoded bandwidth.
  • Port to Jaguar1 / Jaguar2 / MT7612U. tx_no_agg_ok is false there by design. Jaguar2 shares the halmac descriptor (SET_TX_DESC_BK dword2[16]) so it is likely the same two writes; Jaguar1's 8812A descriptor and the MT7612U TXWI need their own look. Each needs an on-air arm, not a code-reading.
  • Cross-rate fold on the 8822C is deeper than on the 8822E (24 % vs 40 % of MCS0 frames kept their rate unflagged, same script, same knobs). Unexplained. Candidates: USB high-speed vs SuperSpeed feed depth, or a die difference in how many MPDUs the MAC waits to accumulate. One unit per die so far.
  • 8812EU on the OpenIPC bench drops off the USB bus about 1 s after the TX bring-up reset (dmesg disconnect + re-enumerate; doctor HEALTHY on EFUSE/fw/RX). It ran a 60 s flood on 2026-09-26, so the bench changed. Rig, not code, but it is why the EU arm was not repeated here.
主要语言
C
星标
56
派生
29
平均合并
3 小时 43 分钟
30 天内合并 PR
75

环境准备

这个项目没有提供开发容器、Dockerfile 或贡献指南,环境需要你自己搭建:先看它的 README,通用步骤见我们的新手贡献指南。

从这里开始

  1. 先读完整个 Issue,再读项目的贡献指南。
  2. 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
  3. Fork 仓库,在一个分支上完成修改。
  4. 提交 Pull Request,并在描述里引用这个 Issue 编号。

OpenIPC/devourer 的其他 Issue

查看 OpenIPC/devourer 的全部 Issue

相似的 Issue

更多 C Issue

把新 issue 发到你的邮箱

精选适合新手参与的 GitHub issue 摘要。