mobile: a Mac on Cloudflare WARP is not reachable on its published addresses

Abierto
#113 1 comentario 0 reacciones 0 asignados Ver en GitHub

Los mantenedores suelen responder en 1 día

Nadie ha tomado este issue todavía.

Evaluación

Dificultad
4/5
Tiempo estimado
3-5 días
Aptitud para principiantes
45/100
Tipo de issue
Error
Claridad
Bastante claro
Estado de actividad
Activo
Stack tecnológico
macos, rust

Línea de trabajo

Start from the atlas-host mobile test setup and the protocol tests that now dial loopback on the published ports, then trace where the endpoint publishes its addresses. Reproduce on a WARP-enabled Mac and determine whether LAN replies are routed through the tunnel. Done means either a reachability test covering tunnel interfaces or a documented limitation, plus a recorded decision on publishing 100.64.0.0/10 and tunnel addresses.

Escrito por el modelo de indexación a partir del texto del issue.

Descripción

Found running atlas-host mobile tests on a dev Mac with WARP (utun4 100.96.0.1, IPv6 2606:4700:…). The endpoint publishes 100.96.0.1, 192.168.68.50 and three IPv6 addresses; an iroh client on the same machine dialing all of them (Minimal preset, no relay) times out after 30 s, the LAN address included. CI has no tunnel and passes.

Open question: does a phone on the same LAN reach that Mac when WARP is on, or does WARP route the replies through the tunnel? If not, pairing silently fails for every WARP user.

The protocol tests now dial loopback on the published ports (they test pairing/scopes, not reachability), so this is tracked here instead of failing the gate on WARP machines. Needs: a reachability test (or doc) for tunnel interfaces, and a decision on publishing 100.64.0.0/10 / tunnel addresses.

Lenguaje dominante
Rust
Estrellas
3
Forks
1
Merge medio
9 h 51 min
PR fusionados (30 d)
310

Preparar el entorno

Primeros pasos

  1. Lee el issue completo y luego la guía de contribución del proyecto.
  2. Comenta en el issue que vas a ocuparte — evita que dos personas hagan lo mismo.
  3. Haz un fork del repositorio y trabaja en una rama.
  4. Abre un pull request que haga referencia al número del issue.

Más de codeatlasdev/atlas

Todos los issues de codeatlasdev/atlas

Issues similares

Más issues de Rust

Recibe los nuevos issues en tu correo

Un resumen breve de issues de GitHub para principiantes.