Hacktoberfest 2026:维护者为十月标记出来的 issue,仍然开放、适合新手。 浏览 Hacktoberfest issue

Dollar limit leaves codeaf do pending until the deadline

未关闭
#1,353 1 条评论 0 个 reaction 已指派 0 人 在 GitHub 查看

维护者通常 1 天内回复

还没有人认领这个 Issue。

评估

难度
4/5
预计耗时
3-5 天
新手友好度
72/100
Issue 类型
缺陷
描述清晰度
描述清楚
活跃度
活跃
技术栈
go

调研方向

Start with settlementWatch.wait and settlementWatch.saySomethingIfQuiet in cmd/codeaf/do.go, then trace TaskReasonOf in internal/session/task_status.go to understand how pending work and budget stops are resolved. Run the described e2e and unit scenarios with stub cost accounting, and inspect internal/manual/chat/running-from-the-terminal.md and models-and-cost.md. Done means exhausted dollar limits produce prompt budget stops while higher limits start the task, with matching documentation and change-entry metadata.

由索引模型根据 Issue 内容生成。

描述

area:headless bug sev:serious

What happened

PRE-EXISTING defect seen on commit 17ae56d34 (staging-20260921-17ae56d3496f) on 2026-09-21 and also on v0.3.0 (9258f7052). Lane A2, item A2-05, set both daily_budget_usd and CODEAF_MAX_COST to 0.001. codeaf do then sat at:

1 task pending, none running

Staging exited 3 after 300 seconds with JSON fields "spend": 0.003388978, "spend_work": 0, "stop": "deadline", and "answer": "The time limit was reached before anything finished...". v0.3.0 behaved the same after 240 seconds. Neither named the dollar limit.

Replication

Deterministic (no model).

No no-model reproduction is established; lane A2 reproduced the blocked launch with live accounting.

Field (real models).

Set OPENROUTER_API_KEY, then prepare a fresh home and repository:

root="$(mktemp -d)"; export CODEAF_HOME="$root/home"; repo="$root/repo"
mkdir -p "$CODEAF_HOME" "$repo" && printf '{"daily_budget_usd":0.001}\n' > "$CODEAF_HOME/config.json"
git -C "$repo" init -q
git -C "$repo" -c user.name=Test -c [email protected] commit --allow-empty -m base
CODEAF_MAX_COST=0.001 codeaf do "write numbers 1 to 3000 into numbers.txt one per line, using a bash loop that sleeps 1 second after each number" --dir "$repo" --yes-spend --json --model deepseek/deepseek-v4-flash --timeout 5m

Today stderr says 1 task pending, none running; after five minutes JSON says "stop":"deadline" and the process exits 3.
Budget five minutes and about $0.01. Repeat with a comfortably higher daily and run limit as the control; the task should start instead of remaining pending. v0.3.0 has the same low-limit defect.

Where

The terminal receipt and quiet-wait paths are settlementWatch.wait and settlementWatch.saySomethingIfQuiet in cmd/codeaf/do.go; the task stop reason is exposed by TaskReasonOf in internal/session/task_status.go. The evidence does not establish why the pending state wins over the budget stop.

The fix

If the daily or run dollar limit prevents all pending work from starting, settle immediately as a dollar-limit stop. JSON must use "stop":"budget" and the answer must say a dollar limit you set stopped it; do not wait for --timeout and call it a deadline.

Acceptance

  • e2e: Through codeaf do --json with a stub cost ledger already beyond CODEAF_MAX_COST=0.001, assert prompt exit 3, "stop":"budget", answer text a dollar limit you set stopped it, and no deadline value.
  • e2e: Through the same door with a higher limit, assert the stub task leaves pending, enters running, and the result is not stopped for budget.
  • Unit: A settlement with pending work, no running work, and an exhausted daily or run dollar allowance maps to budget immediately and cannot later map to deadline.
  • The manual pages internal/manual/chat/running-from-the-terminal.md and internal/manual/chat/models-and-cost.md quote the budget-stop wording and JSON field, and the change entry's invalidates names the old belief that an unstartable dollar-limited task should wait for the time wall.

Filed from the 2026-09-21 staging verification of 17ae56d34; the lane reports, frames and e2e logs are in the owner's handoff folder for this promotion.

主要语言
Go
星标
115
派生
14
平均合并
9 小时 35 分钟
30 天内合并 PR
752

环境准备

我们还没有检查这个项目的环境配置文件。先看它的 README,通用步骤见我们的新手贡献指南。

从这里开始

  1. 先读完整个 Issue,再读项目的贡献指南。
  2. 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
  3. Fork 仓库,在一个分支上完成修改。
  4. 提交 Pull Request,并在描述里引用这个 Issue 编号。

Agent-Field/CodeAF 的其他 Issue

查看 Agent-Field/CodeAF 的全部 Issue

相似的 Issue

更多 Go Issue

把新 issue 发到你的邮箱

精选适合新手参与的 GitHub issue 摘要。