Follow-ups left open by the RTL8852CE PCIe port (#468)
維護者通常 1 天內回覆
還沒有人認領這個 Issue。
評估
研究方向
This issue groups several independent follow-ups rather than one bounded task. Start with the relevant entry points it names: PcieDmaAx, PcieDma88xx, PcieTransport::Open, tests/pcie_rx_smoke.py, and the demo used by the receiver harness. First determine which item is still actionable; done criteria depend on that investigation, and the lab-box hang remains undiagnosed.
由索引模型根據 Issue 內容生成。
描述
Open items from #468 (RTL8852CE on the Kestrel HAL over vfio-PCIe), none of them blocking the merge:
- MSI on the AX plane.
PcieDmaAxpolls the RXQ/RPQ hardware indices every 200 µs. The 88xx plane already wires the vfio MSI eventfd; the AX equivalent isR_AX_HAXI_HIMR00(RXDMA | RPQDMA | RDU) plus the indirectR_AX_PCIE_HIMR00_V1HCI_AXIDMA bit (rtw89rtw89_pci_enable_intr_v1/recognize_intrs_v1). Measure the CPU cost of polling first; it is only worth doing if a receiver on a small host shows it. - Card 05:00.0 TX delivery. On the lab box the E-key card loses ~30% of injected frames to either witness (1383/2000 and 1489/2000) while 09:00.0 delivers 1980/2000 with the same code. Confirm with a reseat / antenna swap / SDR duty read before anything in the driver is suspected; if it follows the slot rather than the module, look at the ASPM/L1 state of that root port.
- The 8821CE plane was moved, not re-run.
PcieDma88xxis a byte-identical move of the old ring code, but no 8821CE is on the box. Runtests/pcie_rx_smoke.pyon the Radxa 8821CE once. - RTL8852BE. Refused at the factory and in
PcieTransport::Open: its PCIe power sequence (mac_pwr_on_nic_pcie_8852b) and the single-BDRAM ring table (rtw89_bd_ram_table_single, non-V1 register set, 8-byte addr_info) are unported. The plane would need the 8852B register bank as a second table. - CAV-cut pre-init rows.
l12_vmain/gen2_force_ib(rtw89, CAV only) are not transcribed; the lab modules are cut 1. Add them if a CAV module ever shows up. timeout -s INTdoes not stop the PCIe rxdemo whilekill -INT <pid>does (clean exit within 5 s). Understand why — a signal-delivery or process-group effect in the demo, not the driver — since every harness that usestimeouton the PCIe receiver silently measures a hard kill.- Lab box hang. During a hung-rxdemo investigation the box went unreachable (pings, sshd pre-auth timeouts) and needed a power cycle; the previous boot's kernel log shows nothing at the hang time (only the pre-fix CmpltAbrt AERs and one DMAR fault, both since fixed). Cause open. A serial console or PDU on that node would have turned this into a diagnosis.
- MMIO alignment doctrine. The transport now splits misaligned accesses; the HALs still issue 32-bit RMWs on 16-bit registers (
R_AX_SYS_FUNC_ENat 0x0002 is the canonical one). Consider a debug-build counter of split accesses so new ones are visible.
🤖 Generated with Claude Code
- 主要語言
- C
- 星號
- 56
- 分支
- 29
- 平均合併
- 3 小時 43 分鐘
- 30 天內合併 PR
- 75
環境準備
這個專案沒有提供開發容器、Dockerfile 或貢獻指南,環境需要你自己搭建:先看它的 README,通用步驟見我們的新手貢獻指南。
從這裡開始
- 先讀完整個 Issue,再讀專案的貢獻指南。
- 在 Issue 下留言說明你要接手 —— 這能避免兩個人做同樣的事。
- Fork 儲存庫,在一個分支上完成修改。
- 送出 Pull Request,並在描述裡引用這個 Issue 編號。
OpenIPC/devourer 的其他 Issue
-
難度 2/5 1-3 小時 新手友好度 82/100
維護者通常 1 天內回覆
-
Follow-ups left open by the 8822B fast bandwidth toggle fix (#584)可能已有人在做 @josephnef 今天認領。 未關閉enhancement
難度 4/5 3-5 天 新手友好度 42/100
維護者通常 1 天內回覆
-
難度 5/5 一週以上 新手友好度 12/100
OpenIPC/devourer#579 · 1 則留言 ·
維護者通常 1 天內回覆
-
enhancement
難度 5/5 一週以上 新手友好度 12/100
維護者通常 1 天內回覆
-
enhancement
難度 5/5 一週以上 新手友好度 8/100
維護者通常 1 天內回覆
相似的 Issue
-
難度 2/5 1-3 小時 新手友好度 72/100
維護者通常 1 天內回覆
-
Needs-Triage
難度 2/5 1-3 小時 新手友好度 66/100
維護者通常 2 天內回覆
-
issue: bug report
難度 2/5 1-3 小時 新手友好度 82/100
維護者通常 2 天內回覆
-
cross-platform fix-now
難度 2/5 1-3 小時 新手友好度 76/100
維護者通常 1 天內回覆
-
feature:index kind:crash status:confirmed triaged
難度 2/5 1-3 小時 新手友好度 77/100
維護者通常 1 天內回覆