Follow-ups left open by M6 (#260): EVM, roam baseline, the named test, residuals

未關閉
#566 0 則留言 0 個 reaction 已指派 0 人 在 GitHub 檢視

維護者通常 1 天內回覆

還沒有人認領這個 Issue。

評估

難度
5/5
預估耗時
一週以上
新手友好度
12/100
Issue 類型
功能
描述清晰度
基本清楚
活躍度
活躍
技術堆疊
c, shell

研究方向

This is a tracking list of deferred M6 work, not one change. Start with src/cell/F1.h and src/cell/UeRxAttribution.h to see where evm_mean_db is computed but never sent, and with docs/cell-m6.md for the residuals. Each item needs hardware runs in the testrig repo's scripts/m6_*.sh suite. Done means each checkbox is either implemented and measured or explicitly recorded as not covered.

由索引模型根據 Issue 內容生成。

描述

enhancement

Part of the 5G-NR RAN EPIC #254. Follow-ups left open when M6 #260 closed on its mechanisms (CHO, DAPS on one channel and across channels, slot migration, per-cell keys, sequence handling and handover state cleanup: #527–#562). The moving-UE test bench is #563; it isn't repeated here.

Deferred from the M6 issue

  • EVM in the measurement reports. #571: filtered EVM in F1 v16 (UeMeas, HeardUe); reported, not used by the A3 (docs/cell-m6.md says why). M6's first deliverable lists RSSI, SNR and EVM. F1 reports only RSSI and SNR, for the DU's own UEs and the UEs it hears (src/cell/F1.h). src/cell/UeRxAttribution.h computes evm_mean_db, but nothing sends it. Doing this needs an F1 version bump, plus a decision on whether the A3 ever uses EVM.
  • The 802.11 roam baseline ("vs the ~100 ms roam ghost bar"). No roam has been measured for comparison. The DL gap at a switch is now 84–123 ms (111–112 plain, same channel; 122–123 across channels with visits), so the claim is "no scan, no re-association, no clock re-acquisition", not yet "a shorter gap". To settle it, measure a plain 802.11 roam on the same radios with the same KPI. #572: measured on the same radios (testrig m6_roam_baseline.sh, rtw89 + hostapd + wpa_supplicant): 0.38–0.66 s DL gap per roam, 5.6–5.9 s returning to the first AP (cause not established); the M6 switch is 84–123 ms.
  • The named test. The M6 issue asked for tests/ran_handover.sh. The tests are testrig scripts/m6_*.sh (handover, crossing, crossing3, three_ho, daps, daps_dl, daps_xch, cellkeys, …), and devourer holds only the ctest cell_m6. Either add a devourer-side entry point that documents and runs the rig suite, or record in docs/cell-m6.md that the rig suite lives in testrig. #572: docs/cell-m6.md records the rig suite (testrig scripts/m6_*.sh) and what each asserts; devourer keeps the headless ctest.

Residuals recorded in docs/cell-m6.md ("Not covered yet")

  • A UE whose source fades before the handover command loses what it misses before the cross-channel DAPS visits begin. The visits start at the accept. #574: the conditional handover (RAN_CHO, F1 v18). The CU prepares early, the target grants from the command, and the UE moves on source_lost or target_better. Across channels, with the source killed after the preparation, the UE moves 4 superframes after its last serving beacon with its DL intact (1.002–1.015 of UE2's); without it the UE is stranded (0.21–0.33). Open: no A3 preparation policy has been tuned (the rig forces it).
  • Re-phasing live cells. #575: RAN_REPHASE (F1 v19, channel-switch IE v2). The CU moves a running DU to the best phase it can reach, with its UEs; the DU steps its TSF at an instant idle in both grids, and its UEs shift with it. On the rig, cell 2 moved 20000 → 51200 live with 1–2 uplinks out of slot; afterwards no suspend gaps, and each DU heard its UE in 0.997–1.000 of superframes (0.90–0.95 before). A move announced and not made costs its UE 8 uplinks, then it is back in slot.
  • More than three cells, and the full tour back into cell 1. A fourth cell needs a seventh radio; the tour needs more than the DUs' 20 dB TX range, which #563 provides.
  • Causes not established (two of the four first listed are now established): the one-uplink loss after switches between cells 51.2 ms apart was Kestrel's beacon timer (the first beacon after a TSF step at the old phase; fixed by the TSF placement in #560); the 1.3 ms beacon jump was a DU asking for its phase after its beacon had started (fixed by ordering, docs/cell-m6.md). Still open: the non-linear power-to-RSSI relation (#563's calibration should settle it); one m6_daps_dl run with DL to the arriving UE ~111 µs late and 13 uplinks lost, not reproduced; and the roam baseline's 5.6–5.9 s return to the first AP (the kernel stack, outside devourer). All three now established (testrig results/2026-11-14-m6-causes.txt):
    • The m6_daps_dl anomaly (arrival DL ~111 µs late, 13 uplinks lost) was a race between a handover and the CU's coordination schedule: both UEs were put on one position. 13 % of handover commands were refused for it. Fixed in #576; after the fix, 25 runs with 0 refusals.
    • The power-to-RSSI non-linearity is the j6412-1 09:00 radio, in both directions. As a transmitter it steps down at 8 dBm commanded; as a receiver it collapses below about −62 dBm. A swap test moves the effect with the radio, and every other link is linear within about 1 dB. The mechanism inside that unit is not established. #577 records it.
    • The kernel roam's 5.6–5.9 s return comes from a stale station at the AP the client left. hostapd's DEL_STATION takes about 430 ms, longer than the client's authentication wait. With the old AP dropping the client as it leaves, every roam took 0.41–0.57 s. #577 records it.
  • Neighbour-list residual: #578: bounded and measured. With the signing material the residual is a genuine beacon re-aired, in two shapes. A store-and-forward relay is beaten by the phase check — on the rig a live relay's copies land ~645 µs off and are refused (0 stale: fresh signature), while genuine beacons land within 8 µs of phase (300 µs tolerance). An on-phase reflector the phase check cannot distinguish is bounded by the signed freshness window: NS IE v3 signs the window length too (CELL_NL_WINDOW_SF, down to 1 superframe, ~205 ms vs ~13 s), and the window is compared on the shared network-superframe timeline so cells may use different lengths. A copy fresher than the window, on phase, is physically the cell's own signal re-radiated — only distance bounding would stop it.
  • Optional: carry the timing advance in the handover command. #573: F1 v17 (UeMeas.ta_us, HoCommand.ta_us, RAN_HO_TA); on the rig the target's first uplinks land within 1–2 µs against ~427 µs without it (79–98 uplinks to settle). Slot hits are equal on this layout; the gain is guard margin.
主要語言
C
星號
56
分支
29
平均合併
3 小時 43 分鐘
30 天內合併 PR
75

環境準備

這個專案沒有提供開發容器、Dockerfile 或貢獻指南,環境需要你自己搭建:先看它的 README,通用步驟見我們的新手貢獻指南。

從這裡開始

  1. 先讀完整個 Issue,再讀專案的貢獻指南。
  2. 在 Issue 下留言說明你要接手 —— 這能避免兩個人做同樣的事。
  3. Fork 儲存庫,在一個分支上完成修改。
  4. 送出 Pull Request,並在描述裡引用這個 Issue 編號。

OpenIPC/devourer 的其他 Issue

查看 OpenIPC/devourer 的全部 Issue

相似的 Issue

更多 C Issue

把新 issue 寄到你的電子郵件信箱

精選適合新手參與的 GitHub issue 摘要。