Fill tool in GraphTool doesn't work if fill point is too close to a boundary

未关闭
#1,473 1 条评论 0 个 reaction 已指派 0 人 在 GitHub 查看

维护者通常 4 天内回复

还没有人认领这个 Issue。

评估

难度
3/5
预计耗时
1-2 天
新手友好度
45/100
Issue 类型
缺陷
描述清晰度
基本清楚
活跃度
冷清
技术栈
perl

调研方向

Start with the fill handling in parserGraphTool.pl and run the four GraphTool examples from the issue's MWE, varying the fill point and snapSizeX. Find where a fill point within half a snapSize of a boundary is discarded or snapped. Done means either the fill works for those cases, or the POD documents the limitation as intended, as the maintainer proposed. Check with the thread first, since the expected behaviour is not yet settled.

由索引模型根据 Issue 内容生成。

描述

If the fill point in a GraphTool fill object is within half of the snapSize of a boundary, then the region does not get filled. See the MWE below.

If this is the expected behaviour then we should put a note in the POD about it.

DOCUMENT();

loadMacros('PGstandard.pl', 'PGML.pl', 'parserGraphTool.pl', 'PGcourse.pl');

$gt1 = GraphTool(
    "{line,solid,(0,0),(0,-1)},
    {fill,(-1/2,0)}"
);

$gt2 = GraphTool(
    "{line,solid,(0,0),(0,-1)},
    {fill,(-.5001,0)}"
);

$gt3 = GraphTool(
    "{line,solid,(0,0),(0,-1)},
    {fill,(-1/4,0)}"
)->with(snapSizeX => 1/2);

$gt4 = GraphTool(
    "{line,solid,(0,0),(0,-1)},
    {fill,(-.251,0)}"
)->with(snapSizeX => 1/2);

BEGIN_PGML
[@ $gt1->generateAnswerGraph() @]*

[@ $gt2->generateAnswerGraph() @]*

[@ $gt3->generateAnswerGraph() @]*

[@ $gt4->generateAnswerGraph() @]*
END_PGML

ENDDOCUMENT();
主要语言
Perl
星标
48
派生
78
平均合并
5 天 13 小时
30 天内合并 PR
9

环境准备

这个项目没有提供开发容器、Dockerfile 或贡献指南,环境需要你自己搭建:先看它的 README,通用步骤见我们的新手贡献指南。

从这里开始

  1. 先读完整个 Issue,再读项目的贡献指南。
  2. 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
  3. Fork 仓库,在一个分支上完成修改。
  4. 提交 Pull Request,并在描述里引用这个 Issue 编号。

openwebwork/pg 的其他 Issue

查看 openwebwork/pg 的全部 Issue

相似的 Issue

更多 Perl Issue

把新 issue 发到你的邮箱

精选适合新手参与的 GitHub issue 摘要。