Make Debug Console REPL have different Requests & Request response settings
还没有人认领这个 Issue。
评估
这个 Issue 还没有评估数据。
描述
Right now, any input into the debug console that's handled by the debug adapter, triggers an entire new update chain. This should be customizable.
If a debug adapter is viewing a large scope, and a debugger "power user" want's to input something into the debug console, for whatever reason, perhaps access/perform commands that can't / shouldn't be / isn't suitable to be shown in the UI, it will trigger an update chain - re-requesting all the data that is displayed, which can be quite a bit. This is a burden for the end-user, as they will have to remember to "close" all scopes before entering any input.
Solution:
Make the requests the debug console handles (evaluateRequest) customizable by being able to set a field on the response object "doNotUpdate" or something like that. I think you're getting what I am aiming for here.
- 主要语言
- HTML
- 星标
- 1.8k
- 派生
- 173
- 平均合并
- 7 天 7 小时
- 30 天内合并 PR
- 2
环境准备
从这里开始
- 先读完整个 Issue，再读项目的贡献指南。
- 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
- Fork 仓库，在一个分支上完成修改。
- 提交 Pull Request，并在描述里引用这个 Issue 编号。
microsoft/debug-adapter-protocol 的其他 Issue
-
难度 2/5 1-3 小时 新手友好度 68/100
-
难度 5/5 一周以上 新手友好度 35/100
microsoft/debug-adapter-protocol#633 · 1 条评论 ·
-
难度 4/5 3-5 天 新手友好度 42/100
-
难度 5/5 一周以上 新手友好度 35/100
microsoft/debug-adapter-protocol#599 · 8 个 reaction ·
-
under-discussion
难度 2/5 1-3 小时 新手友好度 48/100
microsoft/debug-adapter-protocol#596 · 9 条评论 ·