JVM caller(0) returns stale package in closure invoked by BEGIN
维护者通常 1 天内回复
还没有人认领这个 Issue。
评估
调研方向
Start by tracing how JVM caller(0) resolves the active package for closures invoked in BEGIN blocks, using the ExtUtils::ParseXS::Node reproduction around line 5330. Add a focused regression that runs on system Perl, JVM, and interpreter backends, and verify the module loads without changing ExtUtils::ParseXS::Node::ISA. Then rerun the Bitcoin-Crypto 4.005 CPAN target and confirm setup reaches its test suite.
由索引模型根据 Issue 内容生成。
描述
Summary
Loading ExtUtils::ParseXS::Node fails on the JVM backend because caller(0) inside a closure invoked from a BEGIN block reports a stale package. The closure then writes the new subclass's @ISA into ExtUtils::ParseXS::Node::ISA, corrupting the base class hierarchy. Interpreter and system Perl load the same module successfully.
This is a remaining caller-package case related to #1753 and its fix in #1754. That fix covers the Eval::Closure::Sandbox_N caller frame. This case occurs in ordinary package compilation in the large ExtUtils::ParseXS::Node source file.
Reproduction
The CPAN tester run 20261118-104825-43075 selected Bitcoin-Crypto 4.005. Its test suite never started in PerlOnJava. While resolving the Bitcoin::Secp256k1 configure dependency, loading ExtUtils::ParseXS::Node failed:
Recursive inheritance detected in hierarchy of class 'ExtUtils::ParseXS::Node'
BEGIN failed--compilation aborted at ExtUtils/ParseXS/Node.pm line 5330.
The relevant upstream code is structurally:
my $build_subclass;
BEGIN {
$build_subclass = sub {
my $class = caller(0);
no strict 'refs';
@{"${class}::ISA"} = $parent;
};
}
package ExtUtils::ParseXS::Node::INCLUDE_COMMAND;
BEGIN { $build_subclass->(-parent => 'include') }
With JVM DFS tracing enabled, the first declaration creates the valid chain:
INCLUDE @ISA = [Node::include]
Node::include @ISA = [Node::oneline]
Node::oneline @ISA = [Node]
Node @ISA = []
At the INCLUDE_COMMAND declaration, caller(0) resolves to ExtUtils::ParseXS::Node rather than ExtUtils::ParseXS::Node::INCLUDE_COMMAND. The assignment therefore changes Node::ISA to [Node::include]. The subsequent traversal reports the resulting cycle:
Node @ISA = [Node::include]
Node::include @ISA = [Node::oneline]
Node::oneline @ISA = [Node]
CYCLE DETECTED! Node already in visiting set
This identifies a stale package result from the JVM caller/source-location mapping for a closure in a BEGIN block. The visible inheritance-cycle diagnostic is secondary: the Perl source declares a valid subclass chain, and the package misidentification mutates the wrong @ISA.
Results
- PerlOnJava JVM backend: direct
-MExtUtils::ParseXS::Nodeload fails with exit 255. - PerlOnJava interpreter backend: the same module load succeeds.
- System Perl 5.42.2: the same module load succeeds.
- System Perl CPAN oracle for Bitcoin-Crypto 4.005: 77 files, 715 tests, PASS.
- PerlOnJava CPAN run: timed out during dependency setup, before Bitcoin-Crypto's tests began. The fallback Alien::Build setup subsequently stalled while downloading cmake; that stall is downstream of the incorrect caller package and corrupted
@ISA. - Reproduced in checkout
d800eff96c4ea7a6aaab5bb0c586c31e607f1220, Java 24.0.2, macOS, Perl 5.42.2.
Acceptance criteria
caller(0)inside the subclass-building closure invoked by aBEGINblock reports the package active at the call site on the JVM backend, including in a large source file with manyBEGINblocks.- Loading
ExtUtils::ParseXS::Nodesucceeds on the JVM backend and leavesExtUtils::ParseXS::Node::ISAunchanged. - Add a focused project-owned regression that passes on system Perl, JVM, and interpreter backends.
- Re-run the Bitcoin-Crypto 4.005 CPAN target and confirm dependency setup reaches the target test suite.
- 主要语言
- Perl
- 星标
- 67
- 派生
- 8
- 平均合并
- 5 小时 12 分钟
- 30 天内合并 PR
- 131
环境准备
- 提供 Dockerfile 或 Docker Compose 文件
- 没有 Pull Request 模板
- 阅读贡献指南
从这里开始
- 先读完整个 Issue,再读项目的贡献指南。
- 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
- Fork 仓库,在一个分支上完成修改。
- 提交 Pull Request,并在描述里引用这个 Issue 编号。
fglock/PerlOnJava 的其他 Issue
-
area:cpan-port bug
难度 2/5 1-3 小时 新手友好度 70/100
fglock/PerlOnJava#2153 ·
维护者通常 1 天内回复
-
area:cpan-port area:parser bug
难度 2/5 1-3 小时 新手友好度 68/100
fglock/PerlOnJava#2137 ·
维护者通常 1 天内回复
-
area:backend area:cpan-port area:runtime bug
难度 2/5 1-3 小时 新手友好度 76/100
fglock/PerlOnJava#2071 ·
维护者通常 1 天内回复
-
area:runtime documentation enhancement
难度 2/5 1-3 小时 新手友好度 72/100
fglock/PerlOnJava#1579 ·
维护者通常 1 天内回复
-
area:cpan-port bug
难度 3/5 1-2 天 新手友好度 62/100
fglock/PerlOnJava#2157 ·
维护者通常 1 天内回复
查看 fglock/PerlOnJava 的全部 Issue
相似的 Issue
-
Dev-output directory preparation accepts file-valued lib/include paths and fails on dangling links未关闭team-cli
难度 2/5 1-3 小时 新手友好度 70/100
维护者通常 2 天内回复
-
难度 2/5 1-3 小时 新手友好度 66/100
-
难度 1/5 1 小时以内 新手友好度 93/100
维护者通常 1 天内回复
-
难度 2/5 1-3 小时 新手友好度 73/100
inverse-inc/packetfence#9728 ·
维护者通常 1 天内回复
-
fix(char-create): show the real reason a character is refused可能已有人在做 @baphomello 于 1 天前认领。 未关闭
难度 2/5 1-3 小时 新手友好度 84/100
维护者通常 1 天内回复