Не выключение экрана

未关闭
#2,503 0 条评论 0 个 reaction 已指派 0 人 在 GitHub 查看

还没有人认领这个 Issue。

评估

难度
3/5
预计耗时
1-2 天
新手友好度
56/100
Issue 类型
缺陷
描述清晰度
基本清楚
活跃度
活跃
技术栈
cpp
领域
embedded-iot

调研方向

Start by locating the “Wake Up” settings and the screen timeout behavior for watch faces in the firmware; the issue does not name source files or tests. Reproduce with firmware 1.16.1 and Gadgetbridge by selecting “Single Tap,” then compare with the other wake options. Done means the screen turns off after the selected timeout with “Single Tap” enabled.

由索引模型根据 Issue 内容生成。

描述

bug
Verification
  • I searched for similar bug reports (including closed issues) and found none was relevant.
What happened?

НЕ выключается экран при "Single Tap"

What should happen instead?

Через 15с после выбора "Wake Up","Single Tap" экран должен погаснуть.

Reproduction steps

Russian.
Firmware Version 1.16.1. Short Ref e172b9b3 Установка с помощью Gadgetbridge. При выборе "Single Tap" в разделе "Wake Up" экран НЕ гаснет при любом выборе "Watch face". При выбранных Single, Double Taps & Raise, Lower Wrists экран гаснет, как положено через выбранное время. Проблема остаётся после перезагрузки Операционной Системы. Кроме того на экране перезагрузки "Шишка Сосны" расположена горизонтально, номер загрузчика V1.0.1 расположен не снизу, а слева экрана.

Firmware Version 1.16.1. Short Ref e172b9b3 Installation with Gadgetbridge. When choosing "Single Tap" in the "Wake Up" section, the screen does not go out when any choice of "Watch face". With selected Single, Double Taps & Raise, Lower Wrists, the screen goes out, as it should be after the selected time. The problem remains after the Reboot of the Operating System. In addition, on the reboot screen "Pilna Catership" is located horizontally, the V1.0.1 loader number is located not from below, but on the left of the screen.

More details?

No response

Version

pinetime-mcuboot-app-dfu-1.16.1.zip

Companion app

Gadgetbridge 2026.11.0 F-Droid

主要语言
C
星标
3.4k
派生
1.1k
平均合并
6 小时 10 分钟
30 天内合并 PR
5

环境准备

在 Codespaces 中打开

在浏览器里用你自己的 GitHub 账号启动这个项目的开发容器。

  • 没有 Dockerfile 或 Docker Compose 文件
  • 没有 Pull Request 模板
  • 阅读贡献指南

从这里开始

  1. 先读完整个 Issue,再读项目的贡献指南。
  2. 在 Issue 下留言说明你要接手 —— 这能避免两个人做同样的事。
  3. Fork 仓库,在一个分支上完成修改。
  4. 提交 Pull Request,并在描述里引用这个 Issue 编号。

InfiniTimeOrg/InfiniTime 的其他 Issue

查看 InfiniTimeOrg/InfiniTime 的全部 Issue

相似的 Issue

更多 C Issue

把新 issue 发到你的邮箱

精选适合新手参与的 GitHub issue 摘要。