Hacktoberfest 2026: những issue maintainer đã đánh dấu cho tháng Mười, đang mở và phù hợp người mới. Xem issue Hacktoberfest

Pi 5: TLV320AIC3104 (ReSpeaker 2-Mics HAT V2.0) PCM open() returns EINVAL on 6.18.50, works on 6.18.39

Đang mở
#7,672 1 bình luận 0 reaction 0 người được giao Xem trên GitHub

Maintainer thường phản hồi trong vòng 1 ngày

Chưa có ai nhận issue này.

Đánh giá

Độ khó
4/5
Thời gian dự kiến
3-5 ngày
Mức phù hợp với người mới
48/100
Loại issue
Lỗi
Độ rõ ràng
Khá rõ ràng
Mức độ hoạt động
Sôi nổi
Công nghệ
c, linux

Hướng nghiên cứu

Start by comparing the 6.18.39 and 6.18.50 changes under sound/soc/dwc, especially d1140e16d6, which the report identifies as a possible cause. Reproduce with the listed arecord command on both kernels, then investigate why opening the PCM device returns EINVAL on 6.18.50. Done when capture and playback PCM devices open on the newer kernel.

Do mô hình lập chỉ mục viết ra từ nội dung của issue.

Mô tả

Describe the bug

After upgrading from 1:6.18.39-1+rpt1 to 1:6.18.50-1+rpt1 (linux-image-6.18.50+rpt-rpi-2712), opening either PCM of an I2S sound card on RP1 fails with EINVAL. The card is a TLV320AIC3104 codec on a simple-audio-card. Both capture and playback fail, raw hw: included. The card still enumerates normally in /proc/asound/cards, and the kernel logs nothing when the open fails.

Booting the 6.18.39 kernel again, with the same rootfs, overlay and userspace (config.txt differs only in the kernel=/initramfs lines), fixes it completely.

Steps to reproduce
  1. Pi 5 with a Seeed ReSpeaker 2-Mics Pi HAT V2.0 (TLV320AIC3104 at i2c-1 0x18), dtoverlay=respeaker-2mic-v2_0. The overlay is compiled from Seeed's respeaker-2mic-v2_0-overlay.dts and is unchanged between the two kernels.
  2. Boot 6.18.50+rpt-rpi-2712.
  3. Run arecord -D hw:CARD=seeed2micvoicec,DEV=0 -f S16_LE -c 2 -r 48000 -d 1 /dev/null

On 6.18.50:

arecord: main:850: audio open error: Invalid argument

The same happens at -r 16000, through plughw:, and with aplay (playback).

strace shows that the syscall itself is what fails, not alsa-lib:

openat(AT_FDCWD, "/dev/snd/pcmC0D0c", O_RDWR|O_NONBLOCK|O_CLOEXEC) = -1 EINVAL (Invalid argument)

Nothing holds the device (lsof /dev/snd/* is empty), /proc/asound/card0/pcm0c/sub0/status reads closed, and dmesg is empty after the attempt.

Expected behaviour

The PCM opens, as it does on 6.18.39. On 6.18.39 the same command records, playback works, and with capture running at 16 kHz aplay --dump-hw-params reports FORMAT: S16_LE S24_LE S32_LE, CHANNELS: 2, RATE: 16000 (the rate is limited by the running capture stream).

Possible cause (not verified)

The only change under sound/soc/dwc between the two builds appears to be d1140e16d6 "ASoC: dwc: Raise sample rate limit to 768kHz", which changes dw_configure_dai_by_dt() from SNDRV_PCM_RATE_8000_384000 to SNDRV_PCM_RATE_8000_768000. I haven't built a kernel with it reverted, so this is only a suspect. 6.18.50 also contains stable merges that I haven't ruled out. 8946ad8626 ("Revert i2s_stop to the upstream version") is not in 6.18.50.

I'm happy to test a build with d1140e16d6 reverted, or an rpi-update kernel, if that helps.

Device (s)

Raspberry Pi 5

System
  • Raspberry Pi 5 Model B Rev 1.0
  • Raspberry Pi OS (trixie), 64-bit
  • Bad: Linux 6.18.50+rpt-rpi-2712 #1 SMP PREEMPT Debian 1:6.18.50-1+rpt1 (Linux commit cff533aec2fa)
  • Good: Linux 6.18.39+rpt-rpi-2712 #1 SMP PREEMPT Debian 1:6.18.39-1+rpt1 (2026-07-29)
  • Firmware: 2026/09/25 15:59:09, version 1accd665 (release) (embedded)
  • Other: an out-of-tree Hailo PCIe driver (hailo1x_pci) is loaded on both kernels. It does not touch audio.
Logs

dmesg shows nothing at open time. On both kernels, boot shows the codec and card probing normally, and the card appears in /proc/asound/cards as 0 [seeed2micvoicec]: simple-card - seeed2micvoicec.

Additional context

Workaround: pin the old kernel in config.txt with kernel=kernel_2712-6.18.39.img and initramfs initramfs_2712-6.18.39 followkernel, using copies of the 6.18.39 files.

Ngôn ngữ chính
C
Star
13.2k
Fork
5.5k
Merge trung bình
2 ngày 4 giờ
Pull request đã merge (30 ngày)
20

Chuẩn bị môi trường

Dự án này không cung cấp dev container, Dockerfile hay hướng dẫn đóng góp, nên bạn cần tự thiết lập môi trường: hãy bắt đầu từ README và xem hướng dẫn đóng góp lần đầu của chúng tôi để biết các bước chung.

Bắt đầu từ đâu

  1. Đọc hết issue, rồi đọc hướng dẫn đóng góp của dự án.
  2. Bình luận trên issue rằng bạn sẽ nhận — tránh hai người làm cùng một việc.
  3. Fork repository và làm thay đổi trên một nhánh.
  4. Mở pull request có tham chiếu số hiệu của issue.

Issue khác của raspberrypi/linux

Tất cả issue của raspberrypi/linux

Issue tương tự

Thêm issue về C

Nhận issue mới trong hộp thư của bạn

Bản tóm tắt ngắn những issue GitHub phù hợp với người mới.