SPIKE: ARM cell-node feasibility for warehouse-scale RAN (PTP quality, vfio/SMMU, USB-tier PinBeaconTbtt discipline)
Maintainer thường phản hồi trong vòng 1 ngày
Chưa có ai nhận issue này.
Đánh giá
- Độ khó
- 5/5
- Thời gian dự kiến
- Hơn một tuần
- Mức phù hợp với người mới
- 35/100
- Loại issue
- Tính năng
- Độ rõ ràng
- Đặc tả rõ ràng
- Mức độ hoạt động
- Ít trao đổi
- Công nghệ
- c, docker, linux
- Lĩnh vực
- embedded-iot, networking, performance
Hướng nghiên cứu
Start with README/CLAUDE.md for the stated MediaTek USB limitation, then run the measurement plan on the Orange Pi 5 Plus: check ethtool -T and measure PTP offsets with ptp4l against the I226 baseline. Test the 8821CE/vfio path and measure PinBeaconTbtt over USB; document results, blocker scope, and candidate-board assessment. Done means a measured, costed ARM configuration fits a stated timing tier, or the evidence supports keeping x86.
Do mô hình lập chỉ mục viết ra từ nội dung của issue.
Mô tả
Spike under EPIC #254. Question: can a warehouse-scale fleet of cell (gNB-DU) nodes run on ARM SBCs instead of x86 mini-PCs — cheaper, lower-power, and (the real deployment lever) PoE-powered — without giving up the timing tiers the epic depends on?
Context: the proven cell-node stack is x86 (Intel N100-class) + Intel I226 HW-PTP (~290 ns RMS vs Wi-Fi TSF) + RTL8821CE over PCIe/vfio (~12 µs submit-to-air; AP↔PTP hold ~0.67 µs via PinBeaconTbtt). devourer's ARM64 USB path is proven daily; the PCIe transport is x86-validated only. The dev rig purchase (3× J6412 boxes) proceeds regardless — this spike only decides the scale-out tier.
Three gates an ARM cell node must pass
- vfio/IOMMU —
PcieTransportrides vfio-pci, which needs an IOMMU. Most cheap ARM SoCs wire no SMMU in front of PCIe (RK3588, i.MX8M).vfio-noiommuexists but has no DMA mapping API, so our DMA rings would need a physical-address/hugepage scheme — engineering work, not a config flag. - PTP quality of the SoC MAC — "
ethtool -Tshows the bits" ≠ I226-grade. Needs a measured offset distribution per candidate. - USB-tier fallback semantics — an ARM node driving the radio over USB is supported today, but that is the coarse-sync tier (~93 µs transport jitter).
PinBeaconTbttdiscipline quality over USB is unmeasured; its number decides whether warehouse cells need PCIe at all.
Measurement plan (zero-purchase: Orange Pi 5 Plus on hand answers most of it)
- A — PTP bench on RK3588 2.5GbE:
ethtool -T, thenptp4lslave against an i226 master; report offset RMS + tail vs the I226↔I226 baseline. - B — 8821CE in the RK3588 M.2 E-key slot: does it enumerate; does vfio (noiommu) bind; how far does
pcieprobeget. Expected to stop at DMA mapping — document exactly where, and scope the noiommu DMA-ring work if it's the only blocker. - C —
PinBeaconTbtt-over-USB discipline (any host, any generation with beacon support): close the AP↔PTP loop with the radio on USB instead of PCIe; report the hold distribution. This is the highest-value number: if it lands ~10 µs, USB-tier ARM cells are legitimate for everything except tight same-channel slot coordination. - D — paper pass on candidates (only if A–C are promising): RPi5/CM5 (PCIe FPC → E-key, PoE+ HAT, IOMMU status unknown), i.MX8M Plus (TSN-grade PTP, industrial), and the explicit rejects — Realtek-NIC boards (r8169 PTP patchy), MediaTek hosts (16 KB bulk-IN cap, see README/CLAUDE.md).
Exit criteria
Either: a named ARM board + attach mode (PCIe or USB) with measured PTP offset and beacon-discipline numbers fit for a stated tier of the epic (tight vs coarse), plus a costed BOM per node — or: a documented "x86 stays the cell-node platform because gate N fails and closing it costs more than the fleet savings."
Non-goal: porting PcieTransport to noiommu DMA inside this spike — scope it, don't build it.
- Ngôn ngữ chính
- C
- Star
- 56
- Fork
- 29
- Merge trung bình
- 3 giờ 43 phút
- Pull request đã merge (30 ngày)
- 75
Chuẩn bị môi trường
Dự án này không cung cấp dev container, Dockerfile hay hướng dẫn đóng góp, nên bạn cần tự thiết lập môi trường: hãy bắt đầu từ README và xem hướng dẫn đóng góp lần đầu của chúng tôi để biết các bước chung.
Bắt đầu từ đâu
- Đọc hết issue, rồi đọc hướng dẫn đóng góp của dự án.
- Bình luận trên issue rằng bạn sẽ nhận — tránh hai người làm cùng một việc.
- Fork repository và làm thay đổi trên một nhánh.
- Mở pull request có tham chiếu số hiệu của issue.
Issue khác của OpenIPC/devourer
-
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 82/100
Maintainer thường phản hồi trong vòng 1 ngày
-
Follow-ups left open by the 8822B fast bandwidth toggle fix (#584)Có thể đã có người làm @josephnef đã nhận hôm nay. Đang mởenhancement
Độ khó 4/5 3-5 ngày Mức phù hợp với người mới 42/100
Maintainer thường phản hồi trong vòng 1 ngày
-
Độ khó 5/5 Hơn một tuần Mức phù hợp với người mới 12/100
OpenIPC/devourer#579 · 1 bình luận ·
Maintainer thường phản hồi trong vòng 1 ngày
-
enhancement
Độ khó 5/5 Hơn một tuần Mức phù hợp với người mới 12/100
Maintainer thường phản hồi trong vòng 1 ngày
-
enhancement
Độ khó 5/5 Hơn một tuần Mức phù hợp với người mới 8/100
Maintainer thường phản hồi trong vòng 1 ngày
Tất cả issue của OpenIPC/devourer
Issue tương tự
-
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 72/100
Maintainer thường phản hồi trong vòng 1 ngày
-
Needs-Triage
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 66/100
Maintainer thường phản hồi trong vòng 2 ngày
-
issue: bug report
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 82/100
Maintainer thường phản hồi trong vòng 2 ngày
-
cross-platform fix-now
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 76/100
Maintainer thường phản hồi trong vòng 1 ngày
-
feature:index kind:crash status:confirmed triaged
Độ khó 2/5 1-3 giờ Mức phù hợp với người mới 77/100
clice-io/clice#1123 · 1 bình luận ·
Maintainer thường phản hồi trong vòng 1 ngày