Hacktoberfest 2026:メンテナが10月に向けて印を付けた、オープンで初心者向けの issue。 Hacktoberfest の issue を見る

Firmware for the Open Car Controller project.

OpenCarControls/firmware は初心者に優しい?

OpenCarControls/firmware への外部コントリビューターの PR が最近は少なく、どのくらいマージされるかはまだ言えません。 初心者向けのオープンな issue は今はありません。下の一覧に、このリポジトリのほかの issue があります。

スター
1
フォーク
0
オープンの初心者向け issue
0
索引済み issue
35
平均マージ
25分
マージ済み PR(30日)
1
主要言語
Rust
ライセンス
MIT
最終 GitHub push
2026年10月21日
最新の索引
2026年10月21日
コントリビューションガイド
コントリビューションガイドがありません
行動規範
行動規範がありません
初心者向けラベル
good first issue

OpenCarControls/firmware にコントリビュートするには

  1. コントリビューションガイドはないので、README と最近マージされた PR をいくつか読んで、変更の出し方をつかみましょう。
  2. このプロジェクトには dev container があります。Codespaces で開くと、ブラウザですぐに開発環境が手に入ります。
  3. あなたのコントリビュートはプロジェクトの MIT ライセンスで公開されます。
  4. リポジトリをフォローすれば、新しい初心者向け issue が出たときにわかります。下のほかの issue も見てみましょう。
issue を読み込んでいます

誰かが対応中かもしれないイシューは最後に並べています。 すべて日付順に表示

  • Decode the 12V battery voltage and tire pressures
    オープン
    e-gmp

    難易度 3/5 1〜2日 初心者へのやさしさ 55/100

    OpenCarControls/firmware#43 ·

  • Implement the battery preconditioning command
    オープン
    e-gmp

    難易度 5/5 1週間以上 初心者へのやさしさ 25/100

    OpenCarControls/firmware#42 ·

  • Implement the window command
    オープン
    e-gmp

    難易度 5/5 1週間以上 初心者へのやさしさ 25/100

    OpenCarControls/firmware#41 ·

  • Implement the climate control command
    オープン
    e-gmp

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#40 ·

  • Implement the flash lights command
    オープン
    e-gmp

    難易度 4/5 3〜5日 初心者へのやさしさ 48/100

    OpenCarControls/firmware#39 ·

  • Implement the charge port command
    オープン
    e-gmp

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#38 ·

  • Implement the door lock command
    オープン
    e-gmp

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#37 ·

  • Reject basic commands from MQTT until they're authenticated
    オープン

    難易度 3/5 1〜2日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#36 ·

  • Refresh stale docs
    オープン

    難易度 1/5 1〜3時間 初心者へのやさしさ 67/100

    OpenCarControls/firmware#35 ·

  • Clean up E-GMP leftovers
    オープン

    難易度 2/5 1〜3時間 初心者へのやさしさ 77/100

    OpenCarControls/firmware#34 ·

  • Implement the Restart command
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 55/100

    OpenCarControls/firmware#33 ·

  • PC debug HTTP shim listens on all network interfaces
    オープン
    good first issue

    難易度 4/5 3〜5日 初心者へのやさしさ 48/100

    OpenCarControls/firmware#32 ·

  • Make clippy fail CI on warnings and pass workflow inputs through env
    オープン

    難易度 2/5 1〜3時間 初心者へのやさしさ 74/100

    OpenCarControls/firmware#31 ·

  • Virtual car reports reverse while driving
    オープン
    good first issue

    難易度 2/5 1〜3時間 初心者へのやさしさ 86/100

    OpenCarControls/firmware#30 ·

  • MCP2515 hardware masks are too strict
    オープン

    難易度 3/5 1〜2日 初心者へのやさしさ 72/100

    OpenCarControls/firmware#29 ·

  • BLE notifications get silently truncated when the negotiated MTU is too small
    オープン

    難易度 3/5 1〜2日 初心者へのやさしさ 55/100

    OpenCarControls/firmware#28 ·

  • Report CAN bus health and add the dev read-only toggle
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#27 ·

  • Check the car's identity before sending on the bus
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#26 ·

  • Make the CAN bitrate configurable and guard CAN-FD buses
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 25/100

    OpenCarControls/firmware#25 ·

  • Detect a silent CAN bus and mark the state as stale
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 43/100

    OpenCarControls/firmware#24 ·

  • Remove the old BLE CAN-debug path
    オープン

    難易度 3/5 1〜2日 初心者へのやさしさ 56/100

    OpenCarControls/firmware#23 ·

  • Stream CAN frames to SavvyCAN over Wi-Fi
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#22 ·

  • Implement OTA updates and safe mode
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 20/100

    OpenCarControls/firmware#21 ·

  • Store configuration in flash and accept provisioning over BLE
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 25/100

    OpenCarControls/firmware#20 ·

  • Scan for BLE buttons and run their actions
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 38/100

    OpenCarControls/firmware#19 ·

  • BLE pairing on boards without a button accepts any phone for 60 s after every boot
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#18 ·

  • Revoke the bond when a phone is removed
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#17 ·

  • Add MQTT TLS and verify signed commands
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 25/100

    OpenCarControls/firmware#16 ·

  • Fix response routing and dedupe commands across transports
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 42/100

    OpenCarControls/firmware#15 ·

  • Report command availability and reject unavailable commands
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#14 ·

  • Send BLE messages larger than one ATT packet
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 45/100

    OpenCarControls/firmware#13 ·

  • Add CAN bus safety
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#12 ·

  • State looks live while the car is asleep or the CAN bus is silent
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#11 ·

  • Implement CAN logging with SavvyCAN's protocol
    オープン

    難易度 5/5 1週間以上 初心者へのやさしさ 35/100

    OpenCarControls/firmware#10 ·

  • Harden BLE pairing and actually revoke removed phones
    オープン

    難易度 4/5 3〜5日 初心者へのやさしさ 34/100

    OpenCarControls/firmware#9 ·

新しい issue をメールで受け取る

初心者向けの GitHub issue を短くまとめたダイジェスト。