Warm stop can report a refusal under load (a SIGINT race between the warm probe and the child)

Abierto
#139 1 comentario 0 reacciones 0 asignados Ver en GitHub

Los mantenedores suelen responder en 1 día

Nadie ha tomado este issue todavía.

Evaluación

Dificultad
3/5
Tiempo estimado
1-2 días
Aptitud para principiantes
54/100
Tipo de issue
Error
Claridad
Bastante claro
Estado de actividad
Activo
Stack tecnológico
javascript
Área
cli

Línea de trabajo

Read the "Replay by history" instructions and attach the full history mentioned in the issue; the current repro log is only on the maintainer's machine. Then hold the warm probe at a named pause, deliver SIGINT, and check whether the run ends stopped rather than refused. The issue is done when the race is reproduced as a failing test on main and the expected stopped outcome is verified.

Escrito por el modelo de indexación a partir del texto del issue.

Descripción

Seen once, under heavy local load, on #57 at 6c958ed3, in the history "every outcome class, the warm and abort stops", which was later split. The failure read: "the run stopped while its config warmed reported a refusal". The next 4 runs passed.

The likely cause is a race in the CLI: the warm probe's service exits on the same SIGINT before the child handles its own signal.

The log, with its replay line, is at ~/.cache/oracle-grammar/repros/pr57-warm-stop-refusal-6c958ed3.log, which is on the maintainer's machine. Per "Replay by history", the full history should be attached here before the seed shifts.

Next step: hold the warm probe at a named pause, deliver SIGINT, and judge that the run ends stopped, not refused. RED on main if the race is real.

This issue was written by Isaac.

Lenguaje dominante
JavaScript
Estrellas
5
Forks
1
Merge medio
11 h 18 min
PR fusionados (30 d)
66

Preparar el entorno

Este proyecto no incluye contenedor de desarrollo, Dockerfile ni guía de contribución, así que la configuración corre por tu cuenta: empieza por su README y consulta nuestra guía para la primera contribución para los pasos generales.

Primeros pasos

  1. Lee el issue completo y luego la guía de contribución del proyecto.
  2. Comenta en el issue que vas a ocuparte — evita que dos personas hagan lo mismo.
  3. Haz un fork del repositorio y trabaja en una rama.
  4. Abre un pull request que haga referencia al número del issue.

Más de TanStack/oracles

Todos los issues de TanStack/oracles

Issues similares

Más issues de JavaScript

Recibe los nuevos issues en tu correo

Un resumen breve de issues de GitHub para principiantes.