Hardware run: the conformance suites on a NUCLEO-F446ZE

Abierto
  • ¿Algo no está bien?
#112 0 comentarios 0 reacciones 0 asignados Ver en GitHub

Los mantenedores suelen responder en 1 día

Nadie ha tomado este issue todavía.

Evaluación

Dificultad
2/5
Tiempo estimado
1-3 horas
Aptitud para principiantes
34/100
Tipo de issue
Documentación
Claridad
Bien especificado
Estado de actividad
Activo
Stack tecnológico
c, cmake
Área
embedded-iot, testing

Línea de trabajo

Read the “Running the suite” and “Archive the outcome” sections in docs/engineering/hil.md, then use the cm4-nucleo-f446ze preset and tools/hil/archive.py. Run the listed CMake build and ctest commands on a NUCLEO-F446ZE with OpenOCD and arm-none-eabi-gcc. Done means a PR adds the archived run, a short report page, and an updated hardware-runs.json; report failures with the console log.

Escrito por el modelo de indexación a partir del texto del issue.

Descripción

good first issue help wanted

Goal

Run the conformance suites on a NUCLEO-F446ZE and archive the result, so the board moves from "tested on an emulator" to tested on hardware in the support matrix.

You need the board, which is why this needs help: the maintainer has only the F446RE. The F446ZE's description already names its debug probe (OpenOCD, board/st_nucleo_f4.cfg), so no code should be needed.

Steps

The full procedure is in docs/engineering/hil.md ("Running the suite"). For this board:

cmake --preset cm4-nucleo-f446ze -B build/ze-hil -DEMB_TEST_EMULATOR=hil -DEMB_HIL_PORT=/dev/ttyACM0
cmake --build build/ze-hil
ctest --test-dir build/ze-hil --output-on-failure

Use your board's serial port (/dev/ttyACM0 on Linux, /dev/cu.usbmodem… on macOS). The console is USART3 on the ST-LINK's virtual COM port. You need OpenOCD and arm-none-eabi-gcc (see the getting-started guide).

Then archive the run, as hil.md's "Archive the outcome" describes, with tools/hil/archive.py.

Done when

  • A PR adds the archived run under docs/engineering/hil-runs/, a short report page, and the updated hardware-runs.json.
  • If anything fails, open the PR anyway, or comment here with the console log. A failure on real hardware is exactly what this is for.

A cm4-nucleo-f446ze-hil preset, like cm4-nucleo-hil for the F446RE, would be a welcome part of the same PR.

Lenguaje dominante
C
Estrellas
1
Forks
1
Merge medio
14 h 21 min
PR fusionados (30 d)
125

Preparar el entorno

Primeros pasos

  1. Lee el issue completo y luego la guía de contribución del proyecto.
  2. Comenta en el issue que vas a ocuparte — evita que dos personas hagan lo mismo.
  3. Haz un fork del repositorio y trabaja en una rama.
  4. Abre un pull request que haga referencia al número del issue.

Más de EmbLinkOs/EmbLinkRTOS

Todos los issues de EmbLinkOs/EmbLinkRTOS

Issues similares

Más issues de C

Recibe los nuevos issues en tu correo

Un resumen breve de issues de GitHub para principiantes.