Project: Low Shelf/Box Unit for Nido

@iteles requested a low wooden shelf for the Nido area:

“I was trying to open an issue on that this morning when you arrived. I was going to go 1200x300x300”

While I do have some materials in the workshop I can use for this, sadly, our Festool Table Saw #53 has a maximum cut width of 24cm:

So that means we can’t easily cut larger piece of plywood down to 300mm… So I’m thinking of just going to Leroy and getting them to prep the cuts. 💭 However … this shelf unit will only require 1/4 of a full 8x4” sheet. So I either need to wait until we have another project … or … 💭

Gonna setup a cutting station with saw horses and circular saw. 🚧